Work Procedure

NOTE: Save necessary data stored in EPS control unit in CONSULT according to the following instructions:
1. CONSULT
   1. Ignition switch OFF.
   2. Ignition switch ON.
   3. Select "Re/programming, Configuration".
   4. Select "EPS/DAST 3".
      NOTE: If "EPS/DAST 3" is not displayed and EPS control unit data cannot be saved on CONSULT, GO TO 3.
   5. Select "Programming".
   6. Save EPS control unit data on CONSULT according to the CONSULT display.

>>

GO TO 2.

1. 1. Ignition switch OFF and wait for 10 seconds.
   2. Replace EPS control unit. Refer to Removal and Installation .

>>

GO TO 3.

NOTE: Write data saved in CONSULT into a new EPS control unit according to the following instructions:
1. CONSULT
   1. Select "Programming".
   2. Perform programming according to the CONSULT display.

>>

Inspection End.