VCR CONTROL MODULE : Removal and Installation
CAUTION:
Perform "VARIABLE COMPRESSION RATIO BASE POSITION LEARNING". Refer to Work Procedure .
REMOVAL
- Disconnect negative battery terminals, then wait at least three minutes. Refer to Exploded View .
- Partially remove the fender protector (LH). Refer to Exploded View .
- Remove the relay box.
- Disconnect the harness connector from the VCR control module.
- Remove the VCR control module nuts.
- Remove the VCR control module.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Perform "VARIABLE COMPRESSION RATIO BASE POSITION LEARNING". Refer to Work Procedure .