Component Inspection

2WD models 

1. CHECK DRIVE MODE SELECT SWITCH 
   1. Ignition switch OFF.
   2. Disconnect drive mode select switch harness connector.
   3. Check the continuity between drive mode select switch terminals as follows.
      2WD models
      
      

      Drive mode select switch		Condition	Continuity
      Terminals
      1	2	Switch to down-position.	Existed
      		Other than the above.	Not existed
      	6	Switch to up-position.	Existed
      		Other than the above.	Not existed

   Is the inspection result normal?

   YES>>

   INSPECTION END

   NO>>

   Replace drive mode select switch. Refer to Removal and Installation .

AWD models 

1. CHECK DRIVE MODE SELECT SWITCH 
   1. Ignition switch OFF and wait at least 10 seconds.
   2. Ignition switch ON.
   3. Check the indicator of AUTO on drive mode select switch indicator.
   4. Check the illuminated position changes according to the operation when switching the drive mode select switch.

   Is the inspection result normal?

   YES>>

   INSPECTION END

   NO>>

   Replace drive mode select switch. Refer to Removal and Installation .