Values on the Diagnosis Tool
NOTE:
The following table includes information (items) inapplicable to this vehicle: For information (items) applicable to this vehicle, refer to CONSULT display items.
| Monitor item | Data Monitor | ||
|---|---|---|---|
| Condition | Display value | ||
| Steering torque | Engine running | Steering wheel: Not steering (There is no steering force) | Approx. 0.0 Nm |
| Steering wheel: Right turn | Positive value (Nm) | ||
| Steering wheel: Left turn | Positive value (Nm) | ||
| Assist level | Engine running | 100% *1 | |
| EPS warning | Engine running | EPS system is normal | No error |
| Not used | Error1 | ||
| EPS system malfunction | Error2 | ||
| Demanded assistance torque | Engine running | Steering wheel: Not steering (There is no steering force) | Approx. 0 Nm |
| Steering wheel: Right turn | Positive value | ||
| Steering wheel: Left turn | Negative value | ||
| Measured motor current | Engine running | Steering wheel: Not steering (There is no steering force) | Approx. 0 A |
| Steering wheel: Left or Right turn | Displays consumption current of EPS motor *2 | ||
| ECU temperature | Ignition switch ON or engine running | Displays temperature of inside of EPS control unit | |
| Battery voltage | Ignition switch ON | 10.5 - 16 V | |
| Vehicle speed | Vehicle stopped | 0.00 kp/h or mph | |
| While driving | Approximately equal to the indication on speedometer *3 (inside of ±10%) | ||
| ENGINE STATUS | Engine not running | STOP | |
| Engine stall | STALL | ||
| Engine running | RUN | ||
| Engine cranking | CRANK | ||
*1: Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls. However, it returns to 100% when left standing.
*2: Almost in accordance with the value of "Target motor current". It is not a malfunction though these values are not accorded when steering quickly.
*3: It is not a malfunction, though it might not be corresponding just after ignition switch ON