ELECTRIC INTAKE VALVE TIMING CONTROL MODULE : Removal and Installation
CAUTION:
Perform "ELECTRIC INTAKE VALVE TIMING CONTROL LEARNING". Refer to Work Procedure .
REMOVAL
- Disconnect negative battery terminals, then wait at least three minutes. Refer to Removal and Installation .
- Partially remove the fender protector (LH). Refer to Exploded View .
- Remove the relay box.
- Disconnect the harness connector from the electric intake valve timing control module and VCR control module.
- Remove the electric intake valve timing control module and VCR control module bracket.
- Remove the electric intake valve timing control module nuts.
- Remove the electric intake valve timing control module.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Perform "ELECTRIC INTAKE VALVE TIMING CONTROL LEARNING". Refer to Work Procedure .