BCM Input Parameters:
- BI01 PANEL LAMP switch display is LO when panel lamp switch is in off position.
- BI02 PARK LAMP switch display is LO when parklamp switch is in off position.
- BI03 Driver door ajar switch (LT DR AJAR) display is LO when drivers front door is ajar.
- BI04 Passenger door ajar switch (RT DR AJAR) display is LO when passenger's rear door is open.
- BI05 DOOR JAMB switch display is LO when any door is open.
- BI06 Door handle switch (DOOR HNDLE) display is momentarily LO when either outside door handle button is depressed.
- BI08 Low refrigerant pressure switch (A/C PRESS) display is LO when system is low on refrigerant.
- BI09 Washer fluid level switch (WASH FLUID) display is LO when vehicle is low on washer fluid.
- BI17 TURN SIGNAL input (BLANK DISPLAY) is HI when turn signal switch is in OFF position. When either directional is ON, input will toggle between LO and HI, with bulb illuminating in HI state.
- BI18 Brake pressure (BRK PRESS) signal is LO when ABS brake pressure is below set value . This input has no meaning on non-ABS equipped vehicles.
- BI21 Low brake fluid (BRK FLUID) display is LO when brake fluid is low.
- BI22 PARK BRAKE switch display is LO when parking brake is applied.
- BI24 FOGLAMP switch display is LO whenever switch is pressed.
- BI25 SEAT BELT switch display is HI when drivers seatbelt is fastened.
- BI51 GENERATOR FEEDBACK (I-TERM) display is LO when there is generator problem or engine is not running.
- BI71 CRUISE CONTROL BRAKE SWITCH display is HI when cruise ON/OFF switch is ON and brake pedal is not depressed .
- BI75 CRUISE CONTROL ON/OFF SWITCH display is HI when cruise ON/OFF switch is ON and set/coast switch is depressed.
- BI76 CRUISE CONTROL SET/COAST SWITCH display is HI when cruise ON/OFF switch is ON and set/coast switch is pushed.
- BI77 CRUISE CONTROL RESUME/ACCEL SWITCH display is HI when cruise ON/OFF switch is ON and Resume/Accel switch is pushed.
- BI78 HEADLAMPS display is HI whenever headlamp switch is ON.
- BI82 TWILIGHT display is LO whenever headlamp switch is ON.
- BI83 HI BEAM display is LO whenever hi beam switch is ON.
- BI88 LOW OIL display will be HI when engine oil level is low.