LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 1991 >> Custom Cruiser >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Removal & Installation >> Trim Panel >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Trim Panel: Removal

  1. Remove negative battery cable.
  2. Remove armrest switch plate (3), if equipped. See Figure . Insert screwdriver in outward slots to disengage tabs.
  3. Remove power window connector from armrest switch plate (3), if equipped.
  4. Remove power seat connector from armrest switch plate (3), if equipped.
  5. Remove screw (8) connecting bezel assembly (7) to door trim panel (2). Unsnap bezel assembly (7) to remove. See Figure .
  6. Remove side window switch floodlamp, if equipped. Twist 90 degrees to remove.
  7. Remove screws underneath pull handle.
  8. Remove power door lock connector from power door lock switch, if equipped.
  9. Remove inside pull strap handle. See PULL HANDLE  .
  10. Remove armrest. See ARMREST  .
  11. Remove screw (127). See Figure .
    • Door panel screw (127) is located between armrest and map pocket opening of front door.
    • Door panel screw (127) is located below rear edge of carpeted section of rear door.
  12. Remove door trim panel (2) using J 24595-C. See SPECIAL TOOLS  .
    • Loosen setscrew (5) connecting mirror control knob (4) to bezel assembly (7). See Figure .
  13. Remove mirror control knob (4).
  14. Remove courtesy lamp connector from door trim panel (2), if equipped. See Figure .
scientia non olet · About LEMON Manuals