Cruise Control Servo: Service and Repair

1. Remove throttle body intake ductwork, then disconnect retainer at servo blade.

2. Disconnect cruise control cable from servo bracket assembly by releaseing locking tangs

3. Disconnect vacuum hoses and electrical connector.

4. Remove servo bracket nuts, servo and bracket assembly.

5. Remove bolts retaining servo to bracket, then servo.

6. Reverse procedure to install noting the following:

a. Tighten servo to bracket bolts to 14 ft-lbs.


b. Tighten servo bracket nuts to 20 ft-lbs.

c. Retainer must be installed with tang secured over cable stud head.