Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor/Switch Replacement

Removal Procedure
1. Disconnect the negative battery cable.
2. Raise the vehicle.
3. Disconnect the electrical connector from the engine oil pressure sensor.




4. Remove the engine oil pressure sensor.

Installation Procedure

Notice: Refer to Fastener Notice in Cautions and Notices.





1. Install the engine oil pressure sensor.
- Tighten the oil pressure sensor to 16 N.m (12 lb ft).
2. Connect the electrical connector to the engine oil pressure sensor.
3. Lower the vehicle.
4. Connect the negative battery cable.