Front Wheel Toe Adjustment

1. Perform the following steps to remove the small seal clamp:
1.1. Position the steering wheel set in the straight ahead position.
1.2. Loosen the hex nuts on the tie rod (2). Turn tie rod shaft (1) in order to obtain the proper toe angle. Refer to Wheel Alignment Specifications (Front Suspension).
2. Confirm the number of threads showing on each tie rod end is nearly equal.

NOTICE: Refer to Fastener Notice in Service Precautions.





3. Confirm that the tie rod ends are square (3) before you tighten the lock nuts (2).
- Tighten the hex nuts at the tie rod ends to 68 Nm (50 ft. lbs.).

4. Install the seal clamps.

IMPORTANT: Ensure the seals do not twist