Connector Identification
WARNING:
When battery is disconnected, vehicle computer and energy systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery.
CONNECTOR IDENTIFICATION DIRECTORY
| Connector | See Figure |
|---|---|
| Automatic Idle Speed (AIS) Motor | Fig 1 |
| Camshaft Sensor | Fig 2 |
| Coolant Temperature Sensor | Fig 3 |
| Crankshaft Sensor | Fig 4 |
| Distance Sensor | Fig 5 |
| Engine Diagnostic | Fig 6 |
| EGR Solenoid | Fig 7 |
| Fuel Injector | Fig 8 |
| Fuel Pump | Fig 9 |
| Ignition Coil | Fig 10 |
| Manifold Absolute Pressure (MAP) Sensor | Fig 11 |
| Oil Pressure Switch | Fig 12 |
| Oxygen (O2) Sensor | Fig 13 |
| Purge Solenoid | Fig 14 |
| Relays: A/C Clutch, A/C Fan, Auto Shutdown, Fuel Pump & Radiator Fan | Fig 15 |
| Single Board Engine Controller (SBEC) | Fig 16 |
| Throttle Body Charge Temperature Sensor | Fig 17 |
| Throttle Position Sensor (TPS) | Fig 18 |
| 6-Pin Fuel Injector Wiring Harness | Fig 19 |
| 10-Pin Fuel Injector Wiring Harness | Fig 20 |