LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Plymouth >> 1992 >> Voyager Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.5L >> Verification Tests >> Verification Test VER-1
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Verification Test VER-1

  1. Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. Attempt to start engine. If engine does not start, return to TEST NS-1A  .
  2. If engine starts, Single Board Engine Controller (SBEC) was changed, and vehicle is equipped with factory theft alarm, start vehicle at least 20 times so alarm system may be activated when desired. Write mileage from odometer to memory location within replacement SBEC. This will enable new SBEC to operate Emission Maintenance Reminder (EMR) light properly. No-start condition is corrected and repair is now complete.
  3. If engine starts and SBEC has not been changed, connect DRB-II to engine diagnostic connector, and erase faults. No-start condition has been corrected and fault messages have been erased. Repair is now complete. If repaired fault has reset, check if any TECHNICAL SERVICE BULLETINS (TSBs) apply to vehicle. Return to TEST DR-1A - CHECKING SYSTEM FOR FAULTS  if necessary. If another fault exists, return to TEST DR-1A - CHECKING SYSTEM FOR FAULTS  , and follow path specified by other fault.
scientia non olet · About LEMON Manuals