Verification Test VER-3

Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. If another fault was read previously and not corrected, return to TEST DR-1A and follow path specified by other fault. If Single Board Engine Controller (SBEC) has been replaced, perform following:

• If vehicle is equipped with factory theft alarm, start vehicle at least 20 times so alarm system may be activated when desired.
• Write vehicle odometer mileage to memory location within replacement SBEC. This will enable new SBEC to operate Emission Maintenance Reminder (EMR) light properly.
• Connect DRB-II to engine diagnostic connector, and erase faults. Disconnect DRB-II.

To ensure no other fault remains, perform following:

1) If vehicle is equipped with A/C, turn A/C on. Set blower to low speed. On all models, drive vehicle for at least 5 minutes and attain a speed of at least 40 MPH. Ensure transmission shifts through all gears.

2) Upon completion of road test, turn engine off. Restart engine, and let it idle for at least 2 minutes. Turn engine off. Connect DRB-II to engine diagnostic connector.

3) Read all fault messages. If repaired fault has reset, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs), and return to TEST DR-1A if necessary. If another fault exists, return to TEST DR-1A and follow path specified by other fault. If no other faults exist, repair is now complete.