Programming Transmitter With DRB

1. Ensure batteries are approximately 3.2 volts each.
2. Turn the ignition ON, place the transmission in PARK, and make sure the vehicle theft security system (if equipped) is in disarm mode.
3. Select Program RKE under Miscellaneous. If the message BCM is in Programming Mode does not appear, exit and select Program RKE again.
4. Press any button on the transmitter. A single chime tone will acknowledge the RKE module has accepted the transmission.
5. Repeat Step 4 for all transmitters that will be used with this vehicle (up to 4 total).
6. Programming mode will last for 30 seconds. To get out of programming mode sooner, press Back Page.