Crankshaft Position Sensor: Service and Repair

Crankshaft (CKP) Position Sensor:

REMOVE OR DISCONNECT
1. Sensor harness connector at sensor.
2. Sensor to block bolt (1).
3. Sensor from engine.

INSPECT
Sensor O-ring for wear, cracks or leakage. Replace if necessary. Lube new O-ring with engine oil before installing.

INSTALL OR CONNECT
1. Sensor to block.
2. Sensor to block bolt (1).

Tighten
Bolt to 8 Nm (71 lb in)

3. Sensor harness connector.