Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the attaching bolt/screws.
3. Disconnect the MAP sensor electrical connector.
4. Disconnect the MAP inlet vacuum hose.
5. Remove the MAP sensor from the bracket.

INSTALLATION PROCEDURE
1. Install the MAP sensor to the bracket.
2. Connect the MAP inlet vacuum hose.
3. Connect the MAP sensor electrical connector.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the bolts/screws.

Tighten
Tighten the bolts arid screws to 3 N.m (27 lb in).