LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Engine Control System - Removal & Installation) >> Fuel Systems >> Fuel Tank Pressure Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Tank Pressure Sensor: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 rear seat cushion fasteners and swing the rear seat bottom cushion up and out of the way.
  2. Remove sill plate from the left side door opening.
  3. Fold back the carpet in order to maintain metal-to-metal contact while servicing the fuel sender assembly.
  4. Remove the access panel for the fuel sender assembly from the rear seat floor. The panel is held in place by a butyl caulk seal.
  5. Disconnect the fuel sender harness connector (1) from the fuel sender assembly. See Figure .
  6. Disconnect Fuel Tank Pressure (FTP) sensor (2) harness connector from the fuel sender assembly. See Figure .
  7. Remove FTP sensor retaining clip (2). See Fig 1 .
  8. Remove FTP sensor (1) from the fuel sender assembly.
Fig 1: Removing/Installing FTP Sensor Retaining Clip
G00180635Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals