LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (HVAC Systems - Automatic) >> Self-Diagnostic System >> Diagnostic System Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic System Check

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you review DESCRIPTION & OPERATION? If so, go to next step. If not, go to DESCRIPTION & OPERATION  then, go to next step.
  2. Install a scan tool. Does the scan tool power up? If so, go to step  4. If not see SCAN TOOL DOES NOT POWER UP in appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
    3. NOTE: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
  3. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool. Rotate the ignition switch through all positions while observing the ignition switch power mode parameter. Does the ignition switch parameter reading match the ignition switch position for all switch positions? If so go to next step. If not see TEST C: POWER MODE MISMATCH under SYSTEM TESTS in BODY CONTROL MODULES - AURORA article in ACCESSORIES & EQUIPMENT.
  4. Turn ON the ignition, with the engine OFF. Attempt to establish communication with the following control modules:
    • Driver Door Module
    • Powertrain Control Module
    • Instrument Panel Module
    • Dash Integration Module
    Does the scan tool communicate with the control modules? If so, go to next step. If not, see Scan Tool does not communicate with class 2 device in appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  5. Select the display DTCs function on the scan tool for the following control modules:
    • Driver Door Module
    • Powertrain Control Module
    • Instrument Panel Module
    • Dash Integration Module
    Does the scan tool display any DTCs? If so go to next step. If not, see SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
  6. Does the scan tool display any DTCs which begin with a "U"? If so, see Scan Tool does not communicate with class 2 device in appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT. If not, go to next step.
  7. Does the scan tool display DTC B10XX, except B1000? If so, see DIAGNOSTIC TROUBLE CODE INDEX . If not, go to next step
  8. Does the scan tool display DTC B1327? If so, see DIAGNOSTIC TROUBLE CODE INDEX  table. If not, go to next step.
  9. Does the scan tool display any DTCs which are not associated with the HVAC system? If so, see DIAGNOSTIC TROUBLE CODE DEFINITIONS under BODY CONTROL MODULES in COMMUNICATION DEVICES. If not, see DIAGNOSTIC TROUBLE CODE DEFINITION  table.
scientia non olet · About LEMON Manuals