Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Insert the anchor plate through the slit in the carpet.
Align the anchor plate with the raised end forward.
Start the bolt through the anchor plate into the hole in the floor reinforcement.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Important: Insure the anchor plate does not turn while tightening the bolt.
Tighten the child restraint tether anchor plate bolt.
Tighten

Tighten the child restraint tether anchor plate bolt to 27 N.m (20 lb ft).

Fig 1: Installing Child Restraint Tether Anchor Plate & Bolt
Courtesy of GENERAL MOTORS CORP.
Reposition the carpet over the bolt.
Install the child restraint tether, if the child restraint is installed.