Installation Procedure

Fig 1: Rear Wheel Speed Sensors Component View

Courtesy of GENERAL MOTORS CORP.

Connect the rear wheel speed sensor jumper harness connector (1) to the wheel speed sensor, located next to the rear strut (2).

Fig 2: Locating Rear Wheel Speed Sensor Jumper Harness Retaining Clips

Courtesy of GENERAL MOTORS CORP.

Install the rear wheel speed jumper harness (1) into the retaining clips (2).
Connect the rear wheel speed sensor jumper harness connector to the pass thru connector.
Lower the vehicle.
Turn the ignition switch to the RUN position, with the engine off.
Perform the diag system check. Refer to Diagnostic System Check - ABS .