Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bulbs to the tail lamp circuit board.
- Position the tail lamp circuit board to the tail lamp.
- Hold the top 2 locking tabs apart while pushing the tail lamp circuit board into place.
- Hold the bottom 4 locking tabs apart while pushing the tail lamp circuit board into place.
- Verify that the circuit board is fully seated with the locking tabs fully seated.
- Install the 2 tail lamp circuit board retaining screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
- Install the tail lamp. Refer to Tail Lamp Replacement .
NOTE:
Refer to Fastener Notice in Cautions and Notices.