Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Tail Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Install the tail lamp circuit board. Refer to Tail Lamp Circuit Board Replacement .
Connect the tail lamp electrical connector.
Push the tail lamp assembly directly forward in order to seat the 2 locking pins.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 tail lamp assembly retaining screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).