LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Entertainment System) >> Repair Instructions >> Receiver Replacement - Digital Radio >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Connector
    GM1237408Courtesy of GENERAL MOTORS CORP.
  1. Position the receiver near the insulator panel.
  2. Install the antenna electrical connector (1) to the receiver.
    3. Fig 2: Module Mounting View
    GM1237407Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector (1) to the receiver.
    4. Fig 3: Module Mounting View
    GM1236121Courtesy of GENERAL MOTORS CORP.
  4. Install the receiver to the insulator panel.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the nuts retaining the receiver to the insulator panel.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

  6. Install the right closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
  7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About LEMON Manuals