Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the video assembly to the vehicle.
- Lift the and adjust the video assembly in order to install the T-hook (1) to the video player bracket. Ensure the T-hook is fully seated to the bracket.
- Support the front of the video assembly and connect the video assembly electrical connector (2).
- Align the retaining fastener (3) to the corresponding hole in the video player bracket.
- Raise the front of the video assembly to install the retaining fastener (3).
- Partially install the rear retaining bolts.
- Adjust the video display screen to a full open position.
- Partially install the front retaining bolts.
- Fully seat the retaining bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
- Verify the video display for proper operation.
- Close the video display screen.
- Install the bolt cover bezel.
IMPORTANT:
Ensure the lock washers are fully seated, completely exposing the bolt threads.
NOTE:
Refer to Fastener Notice in Cautions and Notices.