Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not attempt to service the video display assembly components.
The video display is serviced only as an assembly.

Turn the ignition switch to the OFF position.

Fig 1: Removing Bolt Cover Bezel

Courtesy of GENERAL MOTORS CORP.

Using a plastic flat bladed tool, carefully remove the bolt cover bezel.

Fig 2: Removing Video Assembly

Courtesy of GENERAL MOTORS CORP.

Fully loosen the two rear retaining bolts. The bolts will remain attached to the video assembly.
In order to expose the two front retaining bolts, adjust the video display screen to a full open position.
Fully loosen the front retaining bolts. The bolts will remain attached to the video assembly.
Close the video display screen.
Slowly lower the front of the video assembly to release the retaining fastener (3).
Support the video assembly and disconnect the electrical connector (2).
Adjust the video assembly in order to release the T-hook (1) from the video player bracket.
Remove the video assembly from the vehicle.