Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Pipe/Hose Components

Courtesy of GENERAL MOTORS CORP.

Install the fuel filler pipe to the vehicle.
Install the push pin fastener (5).
Uncap the fuel tank.
Install the fuel hose (2) to the tank.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the fuel fill hose clamp (1).
Tighten: Tighten the clamp to 2.5 N.m (22 lb in).

Fig 2: Removing/Installing Fuel Fill Pipe Ground Strap

Courtesy of GENERAL MOTORS CORP.

Install the fuel fill pipe ground strap bolt (3).
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Lower the vehicle.

Fig 3: Removing/Installing Fuel Fill Pipe Bracket Nuts

Courtesy of GENERAL MOTORS CORP.

Install the fuel fill pipe bracket nut (2).
Tighten: Tighten the nut to 10 N.m (89 lb in).

Fig 4: Removing/Installing Fuel Fill Pipe Housing

Courtesy of GENERAL MOTORS CORP.

Install the fuel fill pipe housing.
Install the fuel fill cap.