Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and SIR Disabling and Enabling Zone 6 .
- Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door in Doors.
- Peel the rear half of the water deflector away from the door in order to access the side impact sensor.
- Remove the screws that retain the side impact sensor (2) to the door.
- Disconnect the impact sensor electrical connector (1) from the side impact sensor.
- Remove the side impact sensor from the door.
CAUTION:
Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
CAUTION:
Refer to SIR Caution
in Cautions and Notices.