LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Body Front End) >> Repair Instructions >> Hood Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Hood
    GM740670Courtesy of GENERAL MOTORS CORP.
  1. Position the hood to the vehicle with an assistant.
  2. Partially install the 4 bolts that retain the hood to the hinges (3).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Position the hood to the hinges at the previously marked locations with an assistant.

    Tighten:  Tighten the hood retaining bolts to 25 N.m (18 lb ft).

    4. Fig 2: Installing Insulation To Hood
    GM743495Courtesy of GENERAL MOTORS CORP.
  4. Install the hood insulation to the hood.
  5. Install the push-pin retainers (2).
  6. Install the front hood molding. Refer to Molding Replacement - Hood Front (Rainier) or Molding Replacement - Hood Front (Envoy, Envoy XUV, Bravada) in Exterior Trim.
scientia non olet · About LEMON Manuals