LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Body Front End) >> Repair Instructions >> Hood Latch Support Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood latch support to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing Hood Latch Support Bolts
    GM456736Courtesy of GENERAL MOTORS CORP.
  2. Install the hood latch support bolts to the upper tie bar.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the hood latch support nut to the lower tie bar.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

    Fig 2: Installing Hood Latch Support Nut
    GM456737Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts to the upper support bracket at the front bumper fascia. Refer to Fascia Support Replacement - Front Bumper Upper (Impala) or Fascia Support Replacement - Front Bumper Upper (Monte Carlo) in Bumpers.
  5. Install the hood latch to the hood latch support. Refer to Hood Latch Replacement .
  6. Install the upper radiator air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
  7. Close the hood.
scientia non olet · About LEMON Manuals