LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Wheel Alignment Specifications & Adjustment Procedures) >> Repair Instructions >> Front Toe Adjustment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Toe Adjustment

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the small seal clamp from the inner tie rod boot.
  2. Position the steering wheel in the straight ahead position.
  3. Loosen the hex nut on the tie rod (2). Turn the tie rod shaft (1) in order to obtain the proper toe angle. Refer to Wheel Alignment Specifications (Front)  or Wheel Alignment Specifications (Rear) .
  4. Confirm the number of threads showing on each tie rod end is nearly equal.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Confirm that the tie rod ends (3) are square before you tighten the lock nuts (2).

    Tighten:  Tighten the hex nuts at the tie rod ends to 68 N.m (50 lb ft).

    6. IMPORTANT: Ensure the seals do not twist.
  6. Install the seal clamps.
    7. Fig 1: Identifying Tie Rod & Jam Nut
    GM297349Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals