LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Sunroof System) >> Repair Instructions >> Sunroof Track Timing/Synchronization (MD4) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the sunroof window. Refer to Sunroof Window Replacement .

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  2. Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement (PES)  or Sunroof Motor/Actuator Replacement (MD4) .

    Tighten:  Tighten the motor attachment screws to 3.5 N.m (31 lb in).

  3. Connect the electrical connector to the motor/actuator.
  4. Remove the pin (1) from the holes that held the position while installing the drive motor.
    5. Fig 1: Removing Pin (MD4)
    GM1549380Courtesy of GENERAL MOTORS CORP.
  5. Install the headliner. Refer to Headliner Replacement (Impala) or Headliner Replacement (Monte Carlo) .
  6. Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initilization/Teach Process (New Motor)  or Sunroof Motor/Actuator Initilization/Teach Process (Existing Motor) .
  7. Verify the operation of the sunroof.
scientia non olet · About LEMON Manuals