LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 261 (Lighting Systems) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply adhesive GM P/N 12345493 (Canadian P/N 10953488) to the screw.
  2. Position the sensor fork to the pin.
  3. Rotate the sensor in order to align the sensor locator to the hole in the extension bracket.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the brake pedal position sensor screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    5. Fig 1: Brake Pedal Position Sensor Screw
    GM1204637Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2).

    Engage the CPA. The CPA will not engage if the connector is not attached properly.

    6. Fig 2: Electrical Connector & CPA
    GM1204640Courtesy of GENERAL MOTORS CORP.
  6. Calibrate the sensor. Refer to Brake Pedal Position Sensor Calibration Description and Operation .
  7. Install the I/P insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals