LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Entertainment System) >> Repair Instructions >> Receiver Replacement - Digital Radio >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the receiver bracket for foam tape. If the bracket is not equipped, install foam tape as shown (1, 2) to prevent rattles.
    2. Fig 1: View of Receiver Bracket
    GM1323756Courtesy of GENERAL MOTORS CORP.
  2. Connect the antenna connector.
  3. Connect the electrical connector.
  4. Install the electrical connector CPA.
  5. Install the digital radio receiver to the receiver bracket.
    6. Fig 2: View Of Digital Radio Receiver & Receiver Bracket
    GM1203642Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the digital radio receiver nuts.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

  7. Align the receiver and bracket assembly to the studs.
  8. Install the receiver bracket nuts.

    Tighten:  Tighten the nuts to 4 N.m (35 lb in).

    Fig 3: View Of Rear Compartment Trim Panel & Receiver Bracket
    GM907783Courtesy of GENERAL MOTORS CORP.
  9. Install the left rear compartment trim panel. Refer to Compartment Side Trim Replacement - LH Rear in Body Rear End.
  10. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About LEMON Manuals