Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Lock Pillar Retainer & Screws

Courtesy of GENERAL MOTORS CORP.

Install the lock pillar retainer.
Tighten: Tighten the lock pillar weatherstrip retainer screws to 3 N.m (27 lb in).
Apply a 6 mm (0.25 in) x 100 mm (4 in) bead of sealer across the lower edge of the retainer and onto the lock pillar.
Install the weatherstrip. Refer to Weatherstrip Replacement (Coupe and Convertible) or Weatherstrip Replacement (Hardtop) in Stationary Windows.