LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Rear Suspension System) >> Repair Instructions >> Spring Bolt And Insulators Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Tools Required 
  • J 33432-A Transverse Spring Compressor
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS article.
  3. Measure the transverse spring stud height (1). See Figure.
    CAUTION: During this procedure, use care not to scratch rear transverse spring.
  4. Install J 33432-A to the rear transverse spring and compress the spring. See Figure.
  5. Remove the retainers, nuts, insulators and spring bolts (2) from the lower control arm. See Figure.
scientia non olet · About LEMON Manuals