LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Adjustable Pedal System) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake pedal position sensor to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake pedal position sensor bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  3. Connect the brake pedal position sensor electrical connector.
  4. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages, and Console.
    Fig 1: Installing Knee Bolster Trim Panel
    GM712827Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals