LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the controls and the control harness to the steering wheel.
  2. Fig 1: Steering Wheel, Shaft & Nut
    GM294367Courtesy of GENERAL MOTORS CORP.
  3. Install the wiring through the steering wheel.
  4. Install the steering wheel.
  5. Connect the steering wheel control electrical connector.
  6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the steering wheel nut.

    Tighten:  Tighten the nut to 41 N.m (30 lb ft).

  8. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Aztek) or Inflatable Restraint Steering Wheel Module Replacement (Rendezvous) in SIR.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .