LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Sunfire Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L (L61) Introduction >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

NOTE: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
  • The fuel pipe connections
  • The hose connections
  • The areas surrounding the connections
  1. Install the J 34730-1A  to the fuel pressure connection, located on the fuel rail.
    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not drain the fuel into an open container. Never store the fuel in an open container due to the possibility of a fire or an explosion.
  2. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
  3. Open the bleed valve on the fuel pressure gage in order to bleed the air from the gage.
  4. Turn ON the ignition, with the engine OFF.
  5. Command the fuel pump ON with a scan tool until all of the air is bled out of the gage.
  6. Close the bleed valve on the fuel pressure gage.
  7. Command the fuel pump ON with a scan tool.
  8. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals