LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiper System And Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Washer Solvent Container Screws
    GM1257439Courtesy of GENERAL MOTORS CORP.
  1. Position the washer solvent container to the right frame rail.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the lower washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  3. Install the washer pump to the container.
    4. Fig 2: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  4. Install the level sensor to the container.
  5. Connect the washer solvent level sensor electrical connector.
  6. Connect the washer pump electrical connector.
  7. Connect the washer pump hose.
  8. Install the right front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  9. Install the upper washer solvent container screw.

    Tighten:  Tighten the screw to 10 N.m (89 lb in).

    10. Fig 3: Upper Washer Solvent Container Screw
    GM1257439Courtesy of GENERAL MOTORS CORP.
  10. Fill the washer solvent container with washer solvent.
  11. Close the hood.
scientia non olet · About LEMON Manuals