Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Install the trailing arm (3) to the trailing arm bracket.
- Install the bolt (7) and nut (4) to the trailing arm (3) and the trailing arm bracket.
Tighten: Tighten the bolt and nut to 105 N.m (77 lb ft).
- Install the trailing arm (3) to the knuckle (8).
- Install the bolt (6) and nut (2) to the trailing arm (3) and the knuckle (8).
Tighten: Tighten the nut to 70 N.m + 65 degrees (52 lb ft + 65 degrees).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.