Remote Control Door Lock Receiver Replacement

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Remote Control Door Lock Receiver

Courtesy of GENERAL MOTORS CORP.

REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT

Callout	Component Name
NOTE: Refer to FASTENER NOTICE in Cautions and Notices. Fastener Tightening Specifications: Refer to FASTENER TIGHTENING SPECIFICATIONS .
1	Plate Assembly, Instrument Panel (I/P) Tip: Remove the I/P accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY .
2	Screws, Remote Control Door Lock Receiver Bracket (Qty: 3) Tighten: 3 N.m (27 lb in)
3	Bracket, Remote Control Door Lock Receiver
4	Receiver, Remote Control Door Lock Tip: Release the retaining clips to remove the receiver from the bracket. Reprogram the receiver. Refer to REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING & SETUP (DOMESTIC, CANADA & JAPAN) or REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING & SETUP (EXPORT) in Programming and Setup.