LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Grand Prix GXP >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 5.3L - Introduction >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Fuel Feed, EVAP and Fuel Tank Lines
    GM1554561Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel feed line.
  2. Connect the fuel feed (3) and EVAP (4) lines to the fuel tank lines (1, 2). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    3. Fig 2: Rear Fuel/Brake Pipe Retainer
    GM1555277Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel feed line to the retainer.
  4. Close the fuel/brake line retainer (1).
    5. Fig 3: Fuel/Brake Pipe Retainer Bolts
    GM1555275Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel feed line to the retainer.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the fuel/brake line retainer bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    7. Fig 4: Fuel/Brake Line Push In Retainer
    GM1555273Courtesy of GENERAL MOTORS CORP.
  7. Install the fuel feed line to the retainer.
  8. Install the fuel/brake line push in retainer to the underbody.
    9. Fig 5: Fuel/Brake Pipe Retainer Bolt
    GM1555271Courtesy of GENERAL MOTORS CORP.
  9. Install the fuel feed line to the retainer.
  10. Install the fuel/brake line retainer bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  11. Lower the vehicle.
    12. Fig 6: Fuel/Brake Pipe Retainers
    GM1555269Courtesy of GENERAL MOTORS CORP.
  12. Install the fuel feed line to the fuel/brake pipe retainers (1).
  13. Close the fuel/brake pipe retainers (1).
    14. Fig 7: View Of Fuel Feed Line & Evaporative Emission (EVAP) Line
    GM1551868Courtesy of GENERAL MOTORS CORP.
  14. Connect the fuel feed line (1) to the fuel rail. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  15. Position and install the brake master cylinder. Refer to Master Cylinder Replacement .
  16. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  17. Install the fuel fill cap.
  18. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs L26/L32) or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) .
  19. Perform the following steps to inspect for leaks:
    1. Turn ON the ignition for 2 seconds.
    2. turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect the system for leaks.
  20. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
scientia non olet · About LEMON Manuals