Installation Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the antenna cable to the vehicle. Use electrical tape in order to secure the antenna cable to the top of the wiring harness. Secure the cable to the harness at least every 150 mm (6 in).
- Connect the antenna cable to the antenna extension cable.
- Install the carpet. Refer to Front Floor Panel Carpet Replacement .
- Install the lower center pillar trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
- Install the left lower pillar garnish molding. Refer to Lower Pillar Garnish Molding Replacement .
- Connect the antenna cable to the radio antenna module
- Install the headliner. Refer to Headlining Trim Panel Replacement .
- Install the left rear upper quarter trim panel. Refer to Rear Quarter Upper Trim Panel Replacement .
- Install the left rear quarter lower trim panel. Refer to Rear Quarter Lower Trim Panel Replacement .
- Install the rear seat back. Refer to Rear Seat Back Replacement (Folding) or Rear Seat Back Replacement (Non-folding) .
- Install the rear seat cushion. Refer to Rear Seat Cushion Replacement .