Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of BPMV Bracket Nuts

Courtesy of GENERAL MOTORS CORP.

Install the BPMV bracket (4) to the wheel house.

NOTE: Refer to Fastener Notice .

Install the 3 BPMV bracket nuts (1, 2, 3) to the studs on the BPMV bracket (4).
Tighten: Tighten the 3 BPMV bracket nuts to 10 N.m (7 lb ft).
Install the BPMV and EBCM as an assembly to the BPMV bracket. Refer to Brake Pressure Modulator Valve Replacement .
Turn the ignition switch to the RUN position.
Perform the Diagnostic Trouble Code (DTC) List - Vehicle .