Relay Box: Service and Repair

JUNCTION BLOCK REPLACEMENT - ACCESSORY WIRING

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the instrument panel (I/P) compartment access hole cover.




3. Disconnect the body wiring harness from the accessory wiring junction block. Pull the harness away from the block for access.
4. Open the I/P compartment. Access the junction block bolt through the open I/P compartment. Remove the junction block bolt.




5. Disengage the junction block tabs from the passenger knee bolster. Pull the junction block away from the I/P.
6. Remove the junction block.

INSTALLATION PROCEDURE




1. Seat the bottom junction block tabs and snap the top of the junction block to the passenger knee bolster.





2. NOTE: Refer to Fastener Notice in Service Precautions.

Install the junction block bolt.

Tighten the junction block bolt to 10 N.m (89 lb in).
3. Close the I/P compartment.
4. Connect the body wiring harnesses to the junction block.

Tighten the connector bolt to 2.5 N.m (22 lb in).




5. Install the I/P compartment access hole cover.
6. Connect the negative battery cable.