Installation Procedure
- Position the shoulder belt retractor into the center pillar positioning unit with the locking tab in the body structure notch.
- Install the retractor fastener.
Tighten: Tighten the fastener to 45 N.m (33 lb ft).
- Snap the shoulder belt webbing retainer into the center pillar.
- Install the lower garnish molding into the center pillar. Refer to Center Pillar Lower Garnish Molding Replacement .
- Install the seat belt to the seat assembly.
IMPORTANT:
Apply Permatex® 24200 on all restraint fasteners prior to installation.
NOTE:
Refer to Fastener Notice
.