Installation Procedure

Fig 1: Oiling Male Pipe Ends (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

Apply a few drops of clean engine oil onto the male pipe end.

Fig 2: Assembling Connectors (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Push both sides of the fitting together in order to cause the retaining tabs to snap into place.

Fig 3: Ensuring Connection (Metal Collar) Is Secure

Courtesy of GENERAL MOTORS CORP.

After installation, pull both sides of the fitting to make sure the connection is secure.