Structural Brace: Service and Repair

Front End Sheet Metal Support Replacement

Removal Procedure




1. Remove the hood secondary catch and primary latch.
2. Remove the input air temperature sensor (2) connector from the center support (1).
3. Remove the upper fascia plastic retainer from the top of the center support.




4. Remove the following components from the vehicle:

* The 2 bolts
* The center support (2)

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the center support (2) to the vehicle. Secure the support with the 2 bolts.

Tighten the center support bolts to 15 N.m (11 lb ft).




2. Install the input air temperature sensor (2) connector to the center support (1).
3. Install the hood secondary catch and primary latch.
4. Install the upper fascia plastic retainer to the top of the center support.