LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2008 >> G8 GT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.0L - DTC P0336 To DTC P250A >> DTC P0351-P0358 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

    IMPORTANT: Perform Circuit/System Verification  first.
  1. Turn OFF the ignition.
  2. Disconnect the ECM C2 harness connector.
    3. IMPORTANT: A high resistance on any IC circuit can cause a misfire condition, before DTCs P0351-P0358 set.
  3. Disconnect the affected ignition/coil module harness connector.
  4. Test the affected IC circuit for the fault condition identified in Circuit/System Verification .
    • If a condition is detected, repair the circuit as required.
  5. Connect the ECM C2 harness connector.
  6. Exchange the affected ignition coil/module, with the ignition coil/module of a cylinder that is not affected.
  7. Start and run the engine. With a scan tool, monitor the IC circuit parameters.
    • If the circuit status fault identified in Circuit/System Verification  transfers with the ignition coil/module, replace the ignition coil/module assembly.
    • If the circuit status fault identified in Circuit/System Verification  does not transfer with the ignition coil/module, replace the ECM.
scientia non olet · About LEMON Manuals