LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 264 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Current Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Negative Battery Cable
    GM1702510Courtesy of GENERAL MOTORS CORP.
  1. Squeeze the negative battery cable branches together.
    2. IMPORTANT: Ensure the battery current sensor is installed in the correct direction and location on the negative battery cable.
  2. Slide the NEW battery current sensor (2) up onto the negative battery cable to the location previously marked during removal.
  3. Wrap electrical tape around the battery current sensor leg in order to secure the sensor to the negative battery cable.
  4. Install the negative battery cable clips (1) to the cable to the locations previously marked during removal.
  5. Install the negative battery cable. Refer to Battery Negative Cable Replacement .
scientia non olet · About LEMON Manuals